Array Processing

	Float Array Fill	Fills a float array with a specific numeric value.
	Float Array Offset	Adds a specific value to every float array entry.
	Float Array Analysis	Analyses a float array and provides some characteristic values.
	Double Array Analysis	Analyses a double array and provides some characteristic values.
	Integer Array Analysis	Analyses a integer array and provides some characteristic values.
	Array Indexer	Provides access to individual array elements.
	Array Mixer	Mixes up individual arrays.

The Float Array Processing nodes either perform various operations on or extract information from Array Nodes of type Float.

Fill

Returns a new float array of the length specified with the Length property. Up to the length of the input float array, old values are copied over to the new array, all excessive elements will be set to the value of the Fill property.

Offset

Adds the value specified by the Offset property to all elements in the array.

Analysis

Provides a number of output properties containing useful information about the array in general.

Array Indexer

The Array Indexer node provides access to individual elements of an array or to a range of elements. This node is the equivalent to the Array node. The type of array and the number of elements which should be accessed have to be specified when the node is dragged to the Content Editor. Using the buttons on the bottom of the Property Editor you can add and remove elements from the array after the creation has been done. Allowed types are the same as in the Array node. The individual array elements are available as output properties (Value_0000 etc.). The NewArray property also provides these values as an Array property. The event Changed is fired if one of the output properties has changed. The input property IndexStart defines at which index in the source array the reading of the elements should begin. If the last elements in the source array are reached and there are not enough elements to fill all outputs of the Array Indexer, the remaining outputs are set to zero.

Array Mixer

The Array Mixer is able to perform Insert, Remove and Overwrite operations on an incoming Array. The type of array which should be modified has to be specified when the node is dragged to the Content Editor. The initial array content, on which the operations are performed, is specified by the BaseArray property. AutoReset specifies if the output property ResultArray should be reset to BaseArray if the scene is loaded. A manual reset can be triggered by the Reset method. Note that all operation are cumulative and change the active array. All further operation are performed on the modified array!
To insert values to the active array one has to specify the InsertArray, the InsertIndex at which the insertion begins and trigger the Insert method. If the insertion index is larger than the length of the current ResultArray, nothing is inserted!
To remove a range of values in the active array specify the RemoveIndex at which the removal should start and RemoveLength which defines the number of elements to remove. Remove triggers the remove operation.
There are two separated overwrite operations available to perform complex array updates. To overwrite a certain range of values specify the NewArray property, the WriteIndex at which the overwrite should start and trigger the according Overwrite method. Note that an overwrite beyond the end of the active array will not add elements to the active array.